TM 10-4930-351-14
0108 00
REMOVE ENGINE SHROUD, CYLINDER CASING AND GATES. (Refer to figure 4.)
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Combination Wrench, 6 mm
None
Key, socket Head Screw, 5 mm
Equipment Condition:
Engine module removed from pump-engine module
Combination Wrench, 19 mm
Engine oil drained
Combination Wrench, 13 mm
Handle, Socket Wrench, Ratchet, 1/4" Drive
Socket, Deep Well, 7 mm, 1/4" Drive
Extension, Socket, 3 in., 1/4" Drive
Handle, Socket Wrench, Ratchet, 1/2" Drive
Socket, Deep Well, 13 mm, 1/2" Drive
Extension, Socket, 3 in., 1/2" Drive
Screwdriver, Cross Tip, #2
Combination Wrench, 1/4 in.
1.
Remove cable clamp (1) from fuel flow solenoid cable at black start control knob (2).
2.
Remove two socket head cap screws (3) and washers (4). Remove cylinder casing (5).
3.
Remove the socket head cap screw (6), lock washer (7) and flat washer (8) attaching oil cooler (9) to shroud (10).
Discard lock washer (7).
4.
Remove the two cross tip screws (11) at top/intake side of shroud (10).
5.
Remove four socket head cap screws (12) and washers (13) attaching shroud (10). Remove shroud (10).
6.
Remove two cross tip screws (14) attaching gate (15) and bracket (16).
WARNING
Fuel vapors are flammable. Residual fuel may be present in the fuel line. Catch the fuel in a
drain pan. Immediately wipe up any fuel that may spill.
7.
Remove union bolt (17), union (18) and washers (19). Discard washers (19).
NOTE
Support oil cooler during removal of oil lines.
8.
Remove union bolt (20), washer (21) union (22), and spacer (23) connecting the oil supply line to the oil cooler (9).
Discard washer (21).
0108 00-5