TM 10-4930-351-14
0108 00
REMOVE FUEL INJECTORS. (Refer to figure 13.)
This task applies to either fuel injector.
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Combination Wrench, 10 mm
None
(WP 0113 00, Item 3)
Combination Wrench, 13 mm
Equipment Condition:
(WP 0113 00, Item 3)
Cylinder casing removed
Combination Wrench, 17 mm
Valve covers removed
(WP 0113 00, Item 3)
Injector fuel feed lines removed
NOTE
Copper washers under fuel injectors are used to adjust fuel injector protrusion into combustion
chamber of cylinder head. Record the number of washers removed, if any, so that the same
number of new washers will be installed upon reassembly.
1.
Remove brace nut (1), washer (2) and brace (3) from mounting stud (4).
2.
Raise fuel injector (5) for access and remove bolt (6), washer (7), union (8) and washer (9). Discard washers (7 and 9).
3.
Remove fuel injector (5) and washer(s) (10). Note number of washers (10) under fuel injector. Discard washers (10).
6
1
7
2
8
9
3
5
10
4
Figure 13. Fuel Injector Removal
0108 00-17
