TM 10-4930-351-14
0108 00
REMOVE CYLINDER HEAD AND CYLINDER (Refer to figures 14 and 15.)
This task applies to either cylinder head or cylinder.
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Socket, Socket Wrench, Deep Well, 13 mm
Tags, Electrical (WP 0116 00, Item 29)
(WP 0113 00, Item 3)
Handle, Socket Wrench, Ratchet, 3/8" Drive
Equipment Condition:
(WP 0113 00, Item 3)
Fuel injectors removed
Refer to Figure 14.
NOTE
One cylinder head nut is a studnut used to mount the lifting eye and oil fill cap lanyard. Note
location for reassembly.
1.
Remove the four cylinder head nuts (1) and washers (2).
2.
Mark cylinder head to ensure replacement on same cylinder.
3.
Remove cylinder head (3) and copper gasket (4). Discard copper gasket (4).
4.
Remove any remaining gasket material from flange.
NOTE
Tag the location of pushrods before removal. Valve pushrods wear differently. Ensure pushrods
are put back in the same location or the engine may not run properly.
5.
Tag and remove pushrods (5). Remove pushrod pipes (6) and O-rings (7). Discard O-rings (7).
0108 00-18
