TM 55-2840-231-23
2-6. Compressor - Installation
INITIAL SETUP
Applicable Configuration
Consumable Materials
All
Lubricating Oil (item 5, Appendix D)
Antiseize Compound (item 6, Appendix D)
Special Tools
Lockwire (item 7, Appendix D)
Turnover Stand, Tool No. 6795579
Engine Turning Adapter, Tool No.
References
6799790
Para 1-63 thru 1-71
Bleed Valve Tube, P/N 6873354
E N G I N E
/
Use only chrome plated steel or un-
plated steel tools for the disassembly
or reassembly procedures described
in this manual. The use of cadmium
on zinc plated tools is not permitted
since these platings are prone to
chipping and flaking. Should these
chips enter the engine, they may
contaminate the lubrication system,
ultimately clogging the filters or
produce intergranular attack on
nickel or titanium base alloys at
elevated temperatures.
1. Engine
Turnover Stand 6795579.
a. Install engine assem-
bly in the turnover
stand.
b. Rotate engine in
stand to a vertical posi-
tion with combustion
section on the bottom.
NOTE
Check to insure that the compressor
and gearbox mounting flanges are
clean and free of foreign material
which could cause misalinement.
Change 6
2-17
