TM 55-2840-231-23
8-13. Preparing Gas Producer
INITIAL SETUP
Applicable Configuration
All
Fuel Control For Storage and Shipment
Consumable Materials
Lubricating Oil (item 4, Appendix D)
Drycleaning Solvent (item 1, Appendix D)
Corrosion Preventive Compound (item 11, Appendix D)
References
Para 1-36, 1-39, 2-7 and 2-20
TM 38-750
GAS PRODUCER
FUEL CONTROL/
NOTE
The procedure for removing the gas
producer fuel control from the metal
shipping and storage (container is
prescribed in the applicable provisions
of paragraph 2-20.
Prepare the gas producer fuel control for stor-
age, shipment, and installation in a metal
shipping and storage container, MS63048-1, as
follows. The fuel control consists of an air
section and a fuel section; each section must
be treated separately when preparing the unit
for storage and shipment.
Do not permit fuel or oil to enter the
drive body cavity or any air pressure
ports,
a. Install shipping plugs
in the compressor dis-
charge pressure, govern-
ing pressure, Py air
pressure, and regulated
air pressure ports.
Change 9
6-24.6
U.S. Government Printing Office: 1987-754-043/43575
