TM55-2840-251-23
4-1 POWER SECTION (AVIM) (Continued)
4-1-1 REMOVAL (Cont)
4. Remove cotterpin (12). Hold
shouldered stud (16). Remove
nuts (13), two washers (14) and
rod end connector (15) from
shouldered stud (16).
5. Remove cotterpin (17) and nut
(18). Hold shouldered stud (16).
Remove cable end clevis (20) from
reversing lever (21).
6. Remove spacer (19) from
reversing lever (21).
7. Remove inboard nut (22) and
bolt (23) holding retaining
plate (24) and slacken outboard
nut (22). Cut locking wire,
then slacken nut (25) to release
push-pull cable (11) from
lifting bracket (26).
8. Where no retaining plate
(24) is fitted, remove seven nuts
(27) , washers (28) and bolts (29),
then remove lifting bracket (26)
from flange "A" with push-pull
cable (11) attached.
9. Rotate engine in stand so
that propeller gearbox is upper
most.
GO TO NEXT PAGE
4-5
