TM55-2840-251-23
6-9
TEMPERATURE COMPENSATOR (Continued)
6-9-3 INSTALLATION (Cont)
2.
Install compensator bracket (11), complete with
electrical harness and tube assembly (1), to temperature
compensator over coupling (13) and plug (12). Secure
with nuts (10). Torque nut on plug (12) to 60 to 70
inch-pounds and nut on coupling (13) to 38 to 42 inch-
pounds. Lockwire (E.5) nuts (10).
NOTE
Insure tube assembly is supported
during preceding step.
CAUTION
Take special care to avoid damaging
bimetallic disk assembly, when passing
it through rear fireseal mount ring.
3.
Carefully install assembled compensator to engine,
passing tube assembly (5) and bimetallic disk assembly
through retaining plates (8) and seals (9) on rear fireseal
mount ring. Locate compensator bracket (11) on two
studs at flange G.
4. Secure compensator bracket (11) to flange G with
two plain washers and self-locking nuts (6). Torque nuts
to 32 to 36 inch-pounds.
5. Tighten nuts (2) and bolts (3) to secure seals (9) and
retaining plates (8). Torque to 36 to 40 inch-pounds.
GO TO NEXT PAGE
6-44
