TM 55-2840-254-23
2-8.1 ADJUST INTERSTAGE AIR-BLEED ACTUATOR (WITH WATER WASH KIT
2-8.1
P/N 2-200-071-54 INSTALLED) (Continued)
NOTE
Adjustment of interstage air-bleed actuator
can be done with oil cooler removed or
installed. This task is shown with oil cooler
removed. Procedure is the same.
When discharging ignition exciter, remove
one lead at a time and discharge recep-
tacle that lead was removed from. Failure
to do so may result in serious shock when
you are removing second lead. In case of
serious shock, get medical attention.
1. Remove nut (1) and screw (2).
2,
3
4.
NOTE
Steps 2. and 3. apply to both output recep-
tacles.
Remove Iockwire and disconnect coil and cable
assembly lead (3).
Discharge ignition exciter (4) by placing tip of
insulated screwdriver (5) against pin (6) and edge
(7) of receptacle (8).
Place leads (3) to one side.
GO TO NEXT PAGE
2-40.2
C h a n g e
5
