TM 55–2840–254–23
Change 7 2–495
2–63 INSTALL OUTPUT SHAFT SUPPORT HOUSING (Continued)
2–63
CAUTION
In following step 8., be sure to install
output shaft support housing careful-
ly and evenly. You could easily dam-
age the gears or air transfer tube
packings which would cause improp-
er engine operation.
8.
Install output shaft support housing (5),
10 key washers (17) and 10 bolts (18) in inlet
housing (19). Position key washers (17) with
bent single tab (20) pointing aft and hooked
over O.D. of flange (21).
9.
Secure flange (22) of tube assembly (16) as
follows:
a.
Position two key washers (23) with bent
single tab (24) pointing aft and hooked over
outer side of flange (22).
b.
Hold double tabs (25) of two key washers
(23) on flange (22) of tube assembly (16).
Use duckbill pliers.
c.
Install two bolts (26) in inlet housing (19).
10. Bend up double tabs (25 and 27) of 10 key
washers (17) and 2 key washers (23).
INSPECT
GO TO NEXT PAGE
