TM 55-2840-254-23
2-8 ADJUST INTERSTAGE AIR-BLEED ACTUATOR (WITHOUT WATER WASH KIT
2-8
P/N 2-200-071-54 INSTALLED) (Continued)
9.
10.
Adjust nuts (11 and 12) until clearance
between shaft of pin (16) and bottom of slot
(17) is 1/8 to 3/16-inch.
Allow piston (13) to return to open position
by removing finger from union.
Do not allow yoke to twist when torquing
nut. Twisting of yoke may cause binding
and will not allow bleed band to close
properly.
After torquing, two threads must remain
showing below nut. Failure to comply may
cause nut to break loose and prevent bleed
band from closing. Replace bleed band if
two threads do not show.
11. Position yoke (18) against compressor housing
(19) and hold upper nut (11 ). Torque lower nut
(12) to 145 pound-inch.
GO TO NEXT PAGE
2-32
Change 5