TM 55-2840-254-23
2-8 ADJUST INTERSTAGE AIR-BLEED ACTUATOR (WITHOUT WATER WASH KIT
2-8
P/N 2-200-071-54 INSTALLED) (Continued)
NOTE
Adjustment of interstate air-bleed actuator can
be done with oil cooler removed or installed.
This task is shown with oil cooler removed.
Procedure is the same.
When discharging ignition exciter, remove
one lead at a time and discharge receptacle
that lead was removed from. Failure to do so
may result in serious shock when you are
removing second lead. In case of serious
shock, get medical attention.
Remove nut (1) and screw (2).
NOTE
Steps 2. and 3. apply to both output receptacles.
Remove lockwire and disconnect coil and cable
assembly lead (3).
Discharge ignition exciter (4) by placing tip of
insulated screwdriver (5) against pin (6) and edge
(7) of receptacle (8).
Place leads (3) to one side.
GO TO NEXT PAGE
Change 5
2 - 2