TM 55-2840-254-23
5-11 INSTALL ACCESSORY GEAR ASSEMBLY (AVIM) (Continued)
5-11
NOTE
If backlash is less than 0.007 inch, a thin-
ner shim must be installed. If backlash is
greater than 0.013 inch, a thicker shim
must be installed. Increasing or decreas-
ing shim thickness by 0.002 inch will
change backlash approximately 0.001
inch.
o. Select shim (24) from shim selection table.
p. Install shim (24), pinion gear (10), lockring
(23) and nut (15). Hand tighten nut (15).
q. Repeat steps 18b. through e.
GO TO NEXT PAGE
5-68