TM 55-2840-254-23
5-11 INSTALL ACCESSORY GEAR ASSEMBLY (AVIM) (Continued)
5-11
Make sure handle is fully seated and
ratchet selector on torque multiplier
is properly set before applying torque.
Rotating ratchet selector with load on
torque pack can damage unit and in-
jure personnel.
Do not change ratchet selector when
torque load is on torque multiplier.
Damage to equipment or injury to
personnel can result.
r. Install handle (21) in slot (22). Turn handle
clockwise to torque nut. Torque nut to 385
foot pounds.
s. Repeat steps h. through i.
t. Bend lockring tabs (11) 180 degrees apart.
u. Clean compressor rotor pinion gear
(step 23). Install No. 3 bearing pack-
age (Ref. Task 2-72).
v. install torquemeter head assembly (Ref.
Task 9-14).
W. Repeat steps 1. thru 18. If pattern and back
lash still cannot be met, replace pinion gear
(steps 18a. thru t.).
x. Repeat steps 1. thru 18. If pattern and back
lash still cannot be met, replace engine.
GO TO NEXT PAGE
5-69