TM 1-1500-204-23-9
Figure 3-46. Setting Height on a Surface Gauge
Figure 3-47. Rule Depth Gauge
Figure 3-48. Micrometer Depth Gauge
Figure 3-49. Vernier Depth Gauge
(a) Hold the body of the depth gauge
against the surface from which the depth is to be
measured.
(b) Extend the rule into the hole or slot.
(c) Tighten the setscrew to maintain the
setting.
(d) Withdraw the tool from the work and
read the depth on the rule.
(2) Vernier depth gauge. To measure the depth
of a hole or slot with more accuracy than is possible with
a rule depth gauge, proceed as follows:
3-22