NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-3
014 03
1 September 2011
Page 12
f. Build up wire bundles by using MIL-I-22444C tape. E nsure the tape provides a snug, abrasion protective fit
between the wire bundle and the saddle clamp grip halves.
g. Center the tape under the grip halves. If difficulty is experienced in wrapping the tape between the saddle clamp
halves, the tape may be wrapped where the bundle is clear of the arms and then the wrap slipped into position between
the arms. Flush the wrap edges +/- 1/32 inch top and bottom. Do not allow wrap to spiral. See Figure 16.
Connector Inserts
(Although not shown
wiring harness must
be connected prior
Connector
to inserting inserts in
connector shell)
Backshell
Saddle Clamp
Figure 15. 527402 Non-EMI Backshell Assembly
Incorrect
Installation Tape
Saddle Clamp
Tape
Correct
Centered on
Installation
Tape Edges
Aligned + 1/32
Inch
Figure 16. Saddle Clamp Tape Installation
