TM 10-4930-351-14
UNIT MAINTENANCE
ADVANCED AVIATION FORWARD AREA REFUELING SYSTEM MODEL M100A1
REPLACE CABLE ASSEMBLY W101
INITIAL SET-UP:
Equipment Condition:
Tools:
Tool Kit, General Mechanics
Engine module removed from pump-engine module
Materials/Parts Required:
REMOVAL
NOTE
Before beginning removal of cable harness W101, observe general layout of cable
harness as a guide to installation.
1.
Loosen cable loop (1) at rear of engine.
2.
Cut and remove tiedown straps from electrical wiring harness.
3.
Tag and disconnect two fuel shutoff solenoid electrical wires (2) at in-line connectors in wiring harness.
4.
Tag and disconnect electrical wire from engine temperature sensor (3).
5.
At intake manifold, lift boots from air intake heaters (4). Tag and remove electrical wires from air intake heaters.
6.
Tag and remove electrical wire from oil pressure switch (5).
7.
Tag and remove small electrical wire (6) from starter solenoid.
8.
Remove electrical tape, and tag and disconnect two alternator wires (7) at in-line connectors.
9.
At pumpage overtemperature connector 1A1J3 (8), remove the four cross tip screws and flat washers that secure
connector 1A1J3 to module frame. Remove connector; retain mounting flange from rear of connector.
10. At control cable connector 1A1J2 (9), remove the four cross tip screws and flat washers that secure connector 1A1J2 to
the module frame. Remove the connector; retain the mounting flange from rear of connector.
11. At rear of NATO connector 1A1J1 (10), tag and remove the small electrical wires (3 terminal lugs) from the negative
terminal of connector 1A1J1.
INSTALLATION
1.
At rear of NATO connector 1A1J1 (10), install the small electrical wires (3 terminal lugs) to the negative terminal of
connector 1A1J1 as tagged.
2.
From rear of electrical connection panel, insert control cable connector 1A1J2 (9) through center hole in panel, position
and hold the mounting flange on rear of connector, and install and tighten the four cross tip screws and flat washers that
secure connector 1A1J2 to the module frame.
0040 00-1