TM55-2840-251-23
5-2 ACCESSORY GEARBOX ACCESSORY DRIVE SHAFT SEALS (AVIM) (Continued)
5-2-1 REMOVAL
1. At starter-generator drive pad (5), remove retaining
ring (1).
a. Using Puller (T.45), extract seal carrier (2)
complete with seals (3) and preformed packing (4).
b. Remove packing (4).
c. Using Puller (T.73), extract seal (3) from seal
carrier (2).
2. At fuel control unit drive pad (6), remove retaining
ring (1).
a. Using Puller (T.45), extract seal carrier (2)
complete with seals (3) and preformed packing (4).
b. Remove packing (4).
c. Using Puller (T.73) extract seal (3) from seal
carrier (2).
3. At Ng tachometer-generator drive pad (7), vacuum
pump drive pad (8), or power take-off drive pads (9),
remove seal carrier (10), complete with preformed
packing (11) and seal (12), using Puller (T.20) at pad
(7), Puller (T.21) at pad (8), and Puller (T.45) at pads
(9).
Remove preformed packing (11) and use Puller
(T.73) to remove seal (12), except from Ng tachometer-
generator drive seal carrier (10), use Puller (T.49).
GO TO NEXT PAGE
5-6
