TM55-2840-251-23
5-2 ACCESSORY GEARBOX ACCESSORY DRIVE SHAFT SEALS (AVIM) (Continued)
5-2-2 INSTALLATION
1. At starter-generator drive pad (5) or fuel control unit
drive pad (6), immerse seal (3) in Lubricating Oil (E.2)
or (E.71) at 175° to 195°F (79°
to 91°C)
until seal is
pliable.
2. Install seal in carrier (2), lip of seal trailing, using
hand pressure or Drift (T.8).
3. Install preformed packing (4) on seal carrier (2).
4. Install carrier (2), using Drift (T.8) and hand pressure
only.
5. Install retaining ring (1).
GO TO NEXT PAGE
5-7
