TM55-2840-251-23
5-2 ACCESSORY GEARBOX ACCESSORY DRIVE SHAFT SEALS (AVIM) (Continued)
5-2-2 INSTALLATION (Cont)
6. To install seal (12) at Ng tachometer-generator drive
pad (7), vacuum pump drive pad (8) or power take-off
drive pads (9), immerse seal (12) in Lubricating Oil (E.2)
or (E.71) at 175°
to 195°F (79' to 91°C)
until seal is
pliable.
7. Install seal in carrier (10), lip of seal trailing, using
hand pressure or Drift (T.8).
8. Install preformed packing (11) on seal carrier (10).
9. Install carrier (10), using Drift (T.8) and hand
pressure only.
FOLLOW ON MAINTENANCE:
Installation Ng Tachometer-
generator (TM55-1510-209-23)
Installation Fuel Pump
(Task 6-3-2)
Installation Fuel Control Unit
(Task 6-1-3)
Installation Starter-generator
(TM55-1510-209-23)
END OF TASK
5-8
