TM 55-4920-328-13
(3) Install the adapters (8), three places on
the mount ring, using washers (9, 11) and bolts (10, 12).
(4) Remove the nuts (14) and washers (13)
from the bolts (16), three places.
(5) Position and align the engine inside the
mount ring. Carefully guide the bolts (16) into the
mating holes of the adapters (8).
(6) Install the washers (13) and nuts (14) on
the bolts (16), three places. Tighten the nuts to 475 +
25 inch-pounds torque, then install a cotter pin (15)
through each bolt and bend the legs of the cotter pins to
secure the installation.
(7) Remove the lifting bar assembly (1,
figure 2-40) in the reverse order of installation outlined
in subparagraph a. above.
1. Flat Gasket - (Part of Mount)
2. Circular Gasket - (Part of Mount)
3. Flat Gasket - (Part of Mount)
4. Mount - LM-412-SA11
5. Washer- MS20002C6
6. Bolt - NAS146DH-14
7. Bolt - NAS146DH-44
8. Adapter- LTCT20832-01
9. Washer- MS35338-46
10. Bolt - MS9532-10
11. Washer - MS35338-48
12. Bolt - MS9534-08
13. Washer - AN960-716
14. Nut - AN310-7
15. Cotter Pin - MS24665-285
16. Bolt - NAS147A-69
Figure 2-41. T74 Engine Mounting Provisions
2-153
