f. Attach the sling assembly (10) to the plates (7), then
raise the water brake assembly (14) to a position aft of
and aligned with the shaft (1).
TM 55-4920-328-13
g. Align the match marks on the shaft (1) and splined
adapter (4) and mate these parts. Install 10 washers
(13) and 10 bolts (12). Tighten and lockwire the bolts.
h.
Remove the sling assembly (10), screws (8),
washers (9), and plates (7). Stow all parts in a
convenient area for reuse after engine test.
1.
Shaft - (Part of LTCT22155-01)
2.
Packing - ARP568-246
3.
Backup Ring - 8-246-V377-90
4.
Splined Adapter - (Part of LTCT22155-01)
5.
Washer - (Part of Water Brake Assembly)
6.
Spanner Nut - (Part of Water Brake Assembly)
7.
Plate- LTCT21966-01
8.
Screw - MS1699780
9.
Washer - MS3533845
10. Sling Assembly - LTCT2196701
11. Torque Element Assembly - LTCT2153801
12. Bolt - AN6H7A
13. Washer - AN960C616
14. Water Brake Assembly - LTCT21701-01
Figure 2-49. Installation of Water Brake Assembly.
2-189