TM 55-4920-328-13
(7)
Install three bolts (32 and 37, figure 2-58)
and three washers (33). Leave bolts loose.
CAUTION
Guide pins on baseplate of PAS and LDS
transmitter must be properly inserted into
HMU when torquing bolts (32, 36, and 37) or
damage will result to the baseplate and pins.
(8)
Torque bolts (32, 36, and 37) to 55-70 inch-
pounds.
(9)
Torque PAS cable (32, figure 2-59) and LDS
cable (33) coupling nuts on PAS and LDS position
indicators (see figure 2-58) to 45-50 inch-pounds.
Lockwire coupling nuts together.
h.
Install electric starter (51, figure 2-58) as follows:
CAUTION
Do not damage threads on studs (53) when
installing starter (51).
(1)
Insert splined clutch jaw assembly (44) into
starter pad on accessory gearbox.
(2)
Measure distance from face of gearbox
starter pad to top of ratchet teeth. Distance must be
0.840
0.010 in. (2.134 0.025 cm.). If distance is within
limits, go to step (3). Otherwise, remove splined clutch
jaw assembly and shim as necessary with shims (45).
(3)
Install preformed packing (43) on spline of
clutch jaw assembly.
TM 55-4920-328-13
(4)
Secure splined clutch jaw assembly (44) to
gearbox starter pad with screw (46) and preformed
packing (47). Torque screw to 180-200 inch-pounds.
(5)
Install lockwasher (48) and retaining ring
(49).
(6)
Install starter (51) onto four studs (53). It
may be necessary to remove axis-A cover and rotate
accessory gearbox to align spline.
(7)
Install four nuts (50) onto studs (53).
Torque nuts to 130-150 inch pounds.
i.
Connect fuel supply hose 17A8586GO1 (21,
figure 2-59) as follows:
(1)
Hose (21) and gasket (22) to fuel pump.
CAUTION
Be sure bolts (23, figure 2-59) for fuel supply
connection to fuel pump are silver plated.
(2)
Lubricate (see paragraph 2-61 step a.) and
install four bolts (23). Torque bolts to 45-50 inch-
pounds.
j.
Attach fuel inlet pressure hose 17A8585G02 (24)
to fitting on fuel supply hose (21). Torque coupling nut
(25) to 135-150 inch-pounds.
k.
Install
connectors
of
thermocouple
harness
17A8575P01 as follows:
(1)
Connect P2 TOP to upper receptacle (2) on
inlet screen.
Change 5 2-238.1/(2-238.2 blank)
