TM 55-4920-328-13
1. Data Acquisition Assembly
2. Upper Receptacle
3. Lower Receptacle
4. Lube Scavenge Thermocouple
5. Thermocouple Receptacle
6. Thermocouple Receptacle
7. Hose (Compressor Discharge)
8. Cap
9. Midframe P3 Reducer)
10. Coupling Nut
11. Hose (Water Brake Pressure IN)
12. Hose (Water Brake Pressure OUT)
13. Pressure Fitting
14. Pressure Fitting
15. Coupling Nut
16. Coupling Nut
17. Strain Gage Cable
18. Harness
19. Transmitter
20. PAS Position Transmitter
21. Hose (Fuel Supply)
22. Gasket
23. Bolt
24. Hose (Fuel Inlet Pressure)
25. Coupling Nut
26. Accessory Gearbox Accelerometer
27. Exhaust Frame Accelerometer
28. Exhaust Frame Accelerometer
29. E1 Connection
30. E3 Connection
31. LDS Position Transmitter
32. PAS Cable
33. LDS Cable
34. Supply Hose
35. Return Hose
36. Bracket
37. Bolt
38. Washer
39. Bolt
40. Nut
41. Connector J16
42. Connector J8
43. Connector M4
44. Connector M11
45. Connector S1
46. Connector M1
47. Connector M2
48. Connector J14
49. Connector J15
50. Connector J9
51. Connector J7
52. Connector J18
53. Connector J12
(2)
Connect P2 BOTTOM to lower receptacle
(3) on inlet and screen.
l.
Connect electrical connectors of water brake
thermocouple harness 17A8628PO1 as follows:
(1)
Connect W/B IN to thermocouple receptacle
(5) on water brake.
(2)
Connect
W/B
OUT
to
thermocouple
receptacle (6) on water brake.
m.
Attach compressor discharge hose 17A8585G01
(7) as follows:
(1)
Remove cap (8) from midframe P3 reducer
(9). Store cap in a convenient area for installation after
test.
(2)
Install COMP DISCHARGE P3 fitting to P3
reducer (9). Tighten (60°
wrench arc) hose coupling nut
(10).
n.
Connect thermocouple harness 17A8575PO1 to
the engine by connecting lube scavenge P3 to the lube
scavenge thermocouple (4).
Change 5 2-242