NAVAIR 01-1A-505-3
TO 1-1A-14-3
TM 1-1500-323-24-3
014 02
1 September 2011
Page 40
Cable
12. Slide the shield termination ferrule under
the shield braid till fully seated.
Center
Shield
Ferrule
Contact
Braid
13. Slide the outer contact body over center/intermediate contact assembly to dimensions below.
Dimensions are after sliding outer body over center/intermediate contact assembly and before crimping.
0.470"
11.94 mm
Pin
Center
Contact
Outer
Shield
Ferrule
0.539"
Cable
Braid
Contact
13.70 mm
Body
Socket
Center
Contact
14. Crimp the outer contact in the area indicated below using tools in Table 5 and NAVAIR 01-1A-505-1,
WP 013 00. Continue to maintain inward pressure on cable while crimping to ensure all parts a properly
seated
Designated
Outer Contact
Crimp Area
Cable
0.118"
3 mm
Push in on Cable
while crimping.
Shield
Braid
Ferrule
15. Trim shield braid even with outer contact body.
Ferrule
Trim Shield
Cable
Braid Even
Outer
With End of
Contact
Outer Contact
Body
Figure 38. 617165, 167065, 167165021 and 617065021 Triaxial Contact Buildup (Sheet 2)